Cessna T206H, 206H

Kit Facts

Type External tip tank
Added fuel total 30 gallons (15 per tank/side)
Useable fuel total 29.8 gallons (14.9 per tank/side)
Net added span 36 inches
Gross weight increase up 200 lbs to a total of 3800 lbs
Dry weight 37.7lbs
Installation time 50-60 hours (with previous installation experience)
Need to be painted Yes
STC and models covered
  • SA4366WE:  206H, T206H
Flight manual supplement (unnecessary if not listed)
Garmin G-1000 For aircraft equipped with the Garmin G-1000 and with the (T)206 Auxiliary Fuel Unlock Card (Cessna P/N 010-00905-02):

Limitations No gross weight increase on H models (S/N 20608060-20608091 and 20608101-20608158) without Cessna Aircraft Company Accomplishment Instruction AI206-57-01 incorporated.

For turbo models slight Vne restriction for flight above 18,000 ft.

Kit price $12,816.00

We’ve been selling these extended tip tanks for the H model 206 since 2000. They carry 30 gallons total, 29.8 usable. They are fiberglass tanks that bolt onto the end of the wing and replace the factory tip. The overall span is increased by 36 inches which results in a better climb and above 10,000 feet, we usually get reports of an additional 3 or 4 kts in cruise speed. The tank has it’s own filler cap and quick drain valve. We ship the tanks in gray primer so they must be painted to match the wing.

For tank installation the close-out rib is removed and if you have strobes, the transformer is re-located to the inboard side of the rib. New holes are drilled in the wing skin and our tank/tip is bolted in place.

The next step is to run the fuel line inboard to the part of the wing where the strut attaches. The transfer pump is mounted here along with two check valves. The fuel line is then run inboard to the main tank. For rubber cell mains, the fuel enters through a tee fitting in the door post into the fuel line that runs from the mains down to the engine. For metal main tanks, a bulk head fitting is installed in the side or top of the main tank.

Gauge(s) and lighted rocker switches are then mounted on the panel, pedestal or over the doors. Apply the placards, fill out the 337 and you’re finished.

The kit is quite complete including tanks, caps, mounting and plumbing hardware, transfer pumps, check valves, fuel line, wire, switches, gauges, fuses, installation drawings and STC. You supply some PRC sealant for the connection to the main tanks.

Local installers complete the job in 50-60 hours but if you have someone do it that has never done one before it will probably take longer. It’s not an exotic installation but, done right, it takes a little time. The installation time does not include the time to paint.