182 (S-T), T181T

Cessna 182S, 182T, T182T

Kit Facts

Type Internal tip tank
Added fuel total 24 gallons (12 per tank/side)
Useable fuel total 23 gallons (11.5 per tank/side)
Net added span N/A
Gross weight increase N/A
Dry weight 34 lbs
Installation time 45-60 hours (with previous installation experience)
Require paint No
STC and models covered
  • SA1758WE : 182S, 182T, T182T
Flight manual supplement (unnecessary if not listed)
Limits Slight Vne restriction for some models. CG shift for some models with fuel in tanks.
Kit price $6,443.00

We’ve been selling these internal tip tanks since 1967. They carry 24 gallons total, 23 usable. They are fiberglass tanks that fit inside the outermost two bays of the wing. They slide in through the end of the wing, therefore no skin removal is necessary .

To begin installation, the close-out rib is removed and a hole is cut in the second rib that is large enough for our tank to slide through. This can be done with a nibbler or a saw. There’s no loss of strength because our tank has a rib built into it. There are anti-abrasion strips bonded onto our tank to prevent chaffing. The tank is a tight fit because we wanted to get the maximum number of gallons in. There is a locating strap that goes around the tank.

A 4 inch hole is cut over the filler cap and a flush fitting door is fitted. A CamLoc is used to hold the door closed. A small hole is cut below the quick drain valve. Under the fuel outlet, an access cover is installed.

The next step is to run the fuel line inboard to the part of the wing where the strut attaches. The transfer pump is mounted here along with two check valves. The fuel line is then run inboard to the main tank. For rubber cell mains, the fuel enters through a tee fitting in the door post into the fuel line that runs from the mains down to the engine. For metal main tanks, a bulk head fitting is installed in the side or top of the main tank.

Gauges and lighted rocker switches are then mounted on the panel, pedestal or over the doors. Apply the placards, fill out the 337 and you’re finished.

The kit is quite complete including tanks, caps, mounting and plumbing hardware, transfer pumps, check valves, fuel line, wire, switches, gauges, fuses, installation drawings and STC. You supply some PRC sealant if your main tanks are metal.

Local installers complete the job in 45 hours but if you have someone do it that has never done one before, it will probably take 60 hours. It’s not an exotic installation but, done right, it takes some time.